Recent content by WmWmson

Re: Everything but the Phantom vision 2 plus, camera and gim Thanks. Just edited my Post

I lost my Phantom Vision 2 Plus this weekend. I am selling the Transmitter (159.00), Range extender(189.00), 3 Sets of never used props(15.00 each x 3 = 45.00), Battery charger (39.00), Mobile device holder (19.00), and 1 battery with about only 15 cycles on it (129.00). Retail Price around...

I could not find the Phantom. The water is dark and very deep. It crashed right on the edge but there is a current and it drops of fast. I was hoping to save some money but it doesn't sound like I can. thanks for the input but I might just sell what I have left for now. Thanks

Ok. I lost my Phantom vision 2 plus this weekend. All pilot error. Was following a friends ski boat on the Black creek and went around a corner and lost sight of the quad. Pushed up to get above the trees and caught a limb over hanging the bank. Now the real question. Is there any where...

I'm some what new to the RC hobby. I've had quadcopters for about 9 or 10 months. I have a phantom, phantom vision 2 plus, a small cheap one from WL toys, and a micro I fly inside. I know we all like to get great video or pictures of crowds and there is the show off factor, but with all the...

I for one would like to thank you for figuring out what went wrong and letting everyone know. I had a Phantom 1 for about 8 months and now have my PV2+. I know there may be some interference or glitch's that may cause some of the problems I read about but I also think a lot are pilot error...

THANKS..... I just check and it was in FPV mode. I don't reminder putting in FPV but it was. I'll try it tomorrow and see but I think you fixed it for me. Thanks for the help.

My gimbal seems to work but not as well as it did the first month. No crashes or hard landing but I did leave the gimbal lock on it for about 20 seconds after I powered on my PV2+. Not sure if that may have caused the problem or not. Here is a short video. Please let me know if there is a...

Just received my new Phanom vision 2 plus. I know there are many openions on this but I would like to hear some of them. Should I update the firmware? And if so to what version? I think I read somewhere to avoid some of them. I have owned a Phantom 1.1.1 for about 8 months and never had any...

I used the power accessory power wire when I fist installed the gimbal. I had drifting problems that way too. I just flew mine again to test with the fy g3 gimbal hooked up and with out it hooked up. Mine seem to fly ok but not as steady as before both ways. I was thinking about adding a...

Ok. I just got the FY G3 Gimbal and installed it on my phantom. Very easy to install and seems to work great. Good instructions helped a lot. The total weight is 1129g with battery, FPV, gimbal, and GoPro. I haven't flow it yet but it seems to work great. I ordered it from GotHeliRC.com on...

Thats what I have and I was really hoping this gimbal would work with stock transmitter. I guess I will keep looking for one that will work out of the box with what I have, good instructions, and not to expencive. I know GOOD LUCK RIGHT.

Do you have the Naza V2?

I am also some what new to this. I'll tell you what I have learned so far. As for gimbals. I bought one for just over 100.00 and it worked great but did not come with instructions and there was not much info on the internet on this one. When I tried to hook up the manual tilt control I think I...

If you figure it out please let me know. I was just going to order it but might wait now. I already burnt one board up not know what I'm doing.