Where is the radio transmitter on p3a? Keep getting "strong signal interference " warning after crash and see nothing wrong.... it will swap between that and 99% strong while sitting on bench next to remote...
Sent from my iPad using PhantomPilots
I reinstalled firmware and checked all wires and connections again.. gimbal will cycle at boot then reads no gimbal attached now
Sent from my iPad using PhantomPilots
Hi all,
I have searched and can't seem to find an answer... I crashed my p3a and had to replace the shell.. and the roll arm... now the gimbal is intermediate along with picture and says signal interference off and on... here is a picture of what I see but if I swap between video and still the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.