I had been working on my Phantom for about a week trying to sort the gps siltation out so yes the cover was off and on numerous times a day and everything was checked many many times..
In the end i started backtracking by removing my upgrades which included the v2 pmu, the additional fpv...
Been flying my Phantom for nearly 6 months without any major problems but I've encountered a strange problem over the last few days..
I’ll run through the procedure.
1.Turn on TX
2.Connect battery
3. Phantom goes through initialization / warm up
4. Green flashes as it set’s home point
5. Red...
DJI brought out an update for the GCU earlier, v1.04 but it didn't fix it as the gimbal continues to screech and get hot so it's now on it's way back to my supplier :(
I've stopped using mine as i believe it's only a matter of time before the heat build up damages the gimbal beyond repair. I'm hoping that DJI will bring out a firmware update that will fix it but i may send mine back anyway as there is no telling what effect the heat has done to it..
Thanks to jonboy for pointing this thread out...
I have the same problem with the Zenmuse screeching and getting hot.. I installed the new v1.02 firmware last night but the problem was still there so i just recalibrated the X1 as suggested above but no joy.. After about a minute of the Phantom...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.