Recent content by wfilleman
-
W
Rotorpixel gimbal for Phantom Vision
I can't say with 100% certainty if the board is 8-bit or 32-bit. What I do know is the 2.2b2 version of the SimpleBGC GUI worked with the RotorPixel included control board found here: http://www.basecamelectronics.com/downloads/8bit/ Without official tuning instructions from RotorPixel, proceed...- wfilleman
- Post #2,816
- Forum: Phantom 2 Vision Discussion
-
W
Rotorpixel gimbal for Phantom Vision
I had the same issues and finally had the time tonight to sit down with the BaseCam software to dig into the SimpleBGC board settings. The good news is I figured it out for my scenario and hope this info helps for others with this same issue. I will preface this with a big "do at your own risk"...- wfilleman
- Post #2,802
- Forum: Phantom 2 Vision Discussion
-
W
RAW with PV
Hi iquittoo, Thanks for the response and suggestion to pop the card back in to repair the file. That's not what happened in my case. I am guilty of doing that the first time and was able to recover the video per the manual suggestion. Also, in that case, my PC was unable to play the file at...- wfilleman
- Post #5
- Forum: Phantom 2 Vision Discussion
-
W
RAW with PV
Hi JC, I've actually had the same experience with video. Filmed maybe 15 flights and three of the flights were all black video. The time stamp of these videos were all in 2008 while the rest of the videos were correct. I am using a 32 GB SANDISK micro card. I just updated the firmware of the...- wfilleman
- Post #3
- Forum: Phantom 2 Vision Discussion