Recent content by vrman

Not sure how bad your crash was, but in my case the GPS sensor in the top shell had cracked. So gps wasn't working 100% anymore. Might want to take a look at it.

You were what, 6 ft off the ground, does that really count as a crash?! :p I know, you still get that gut punch feeling though when that thousand plus dollar kit runs into something. My last crash was when it decided that it wanted to go exploring on its own. It was about 50ft up. Luckily, or...

Sorry to take so long to get back to everyone. cityzen was absolutely correct. There are apparently 2 different compasses being shipped. One without the compass plug, the other with the compass plug. I already received the new one, plugged it in and it showed up in the update tab for firmware. I...

I thought the compass connected to the part connected to one of the legs. There is a difference between the original GPS board and the new one. The old one only has the one connector on it that connects to the gps port on the main board. The new gps board has that plus an additional connector...

Well I noticed something yesterday. On the firmware screen it is not showing any info for the GPS. Is it possible that the previous version of the firmware (1.08) didn't care if there was a GPS attached? Like I said, it worked until I upgraded the firmware. When I replaced the GPS board, after...

I tried it both ways with the TX, since you asked. No difference. This was a brand new GPS board too. Anyway of testing it? Any chance there is something wrong on the main circuit board or the Naza itself? I'd hate to spend another $170 on another GPS board.

I recently replaced the GPS on my P2, as the previous one was cracked and malfunctioning. I did have firmware 1.08 on it. After replacing the GPS I took it out and did a test flight and it seemed ok. I checked the dji site and saw that there was a new version for the firmware. I upgraded to...

I had a similar issue and replaced the GPS board. I also recently upgraded the firmware to v3.12. When I turn on the P2 now, all I get is a slow flashing yellow light (2s on) in phantom or naza mode. If I try to start the motors, I get 5 red flashes, then it goes back to the slow yellow...