Recent content by Veedleschnapper

Thanks for your reply, however, the google search turned up nothing new for me. Hopefully someone who has attempted this will see my post and provide some insight. Cheers

Hi All, I have a Phantom 1.1.1 with the upgrade board installed and currently the zenmuse H3-2D gimbal. I would like to know if anyone out there has successfully upgraded to the H4-3D on this setup, and what they had to do. Also, I still only have the Hero3 black and will upgrade at some...

Did you manage to work out the settings for the zenmuse gimbal? I am having similar problems in that I cannot stop the gimbal from pointing upwards towards the props. Nobody wants to see those so I just want to be able to limit the angle of tilt - anyone got a solution?

Resolved

Here's a picture if it. The two sets of wires at the bottom were the ones that went to X1/X2 and the two on the right are the new ones.

Hi all, I'm a bit of a noob to this and I'm trying to add the upgrade board to the Phantom v1.1.1 so that I can attach the Zenmuse gimbal. The problem I'm having is that I don't know where the cables attach to the Naza. The instructions that came with the kit only show images for the original...

Hi guys, I've just bought a zenmuse gimbal to put onto my Phantom v 1.1.1 and I have also purchased the upgrade kit. I have been trying to find a step-by-step guide on how to do this with my version but all I can find is the naza 1 instructions - can anybody point me in the right direction...

ElGuano - thanks for your reply. I suspected a driver issue myself, so I had already tried that. I have also just downloaded v1.3 of the ZYX software and done an install of 1.3 firmware to both controller and motors. Again, I still have the same issues. As for the motor connectors, neither had...

Hi All, I have been trying to make adjustments to the Tarot gimbal in the ZYX software, so that I can control the angle of tilt and sensitivity. The problem I am having is that each time I try and connect by opening the com port, the software crashes and closes down. It will let me do a straight...

Hi All, I too am encountering this problem. I keep connecting the phantom to the naza software to see if it resolves and it says that everything is fine. So I go out and test it and it works.....for a while. On two occasions, whilst in flight, the lights have flipped from green to flashing...