Recent content by usafloadc17

  1. U

    Help! P4 HDMI Output module users please read!

    Hunch helped me out of a jam! Apparently he has a shop with numerous parts. Thanks again!
  2. U

    Help! HDMI Output Module users read!

    Hunch helped me out of a jam! Apparently he has a shop with numerous parts. Thanks again!
  3. U

    Help! HDMI Output Module users read!

    Ahh, thanks for schooling me to the P3. Still new as I recently left the P2 world. I believe I have the "A". "Model GL300A"
  4. U

    Help! HDMI Output Module users read!

    I'm afraid I'm not following. I need just the USB input board that is removed when the HDMI output module is inserted.
  5. U

    Help! P4 HDMI Output module users please read!

    Hey all, Long story short, I need to find someone who has upgraded to a HDMI output module and is willing to sell their original controller USB board and screws. Anyone?
  6. U

    Help! HDMI Output Module users read!

    Hey all, Long story short, I need to find someone who has upgraded to a HDMI output module and is willing to sell their original controller USB board and screws. Anyone?
  7. U

    P2 Caught on Fire!

    Bump. Any advice on the cause or resoldering? I'll be adding a new board in tomorrow. Can I replace the burned wire with 14 AWG?
  8. U

    P2 Caught on Fire!

    Hey all, Long story short, my P2 caught on fire and crashed. The preview: I blew out the cam/power aux cable port on the main circuit board (part 10) due to hooking up a go pro fpv cable incorrectly (Connected yellow Video to OSD, ground directly to TX). No big deal, I've swapped out main...
  9. U

    Green screen only when outside?!

    Hey guys! I have a new FPV setup on a P2. I'm using a Pz0420 and was ecstatic to hook it up and see an image when I soldered everything together, However, when I go outside, the screen goes completely green? It is an IR sensitive lens. Any ideas? Bad camera?
  10. U

    Phantom making strange whistling noise & Bee attack video

    Funny you mention temps. My left rear motor always ran hot. When I replaced it, it still runs hot. I thought it was a bearing issue, but I now believe it to be a balance issue with my cheap Chinese gimbal. Hopefully a transmitter mounted to the opposite side will help.
  11. U

    Phantom making strange whistling noise & Bee attack video

    Some forums mention the possibility of bad bearings and my Phantom was used, so it was more peace of mind than anything. After some research, a lot of car guys using brushless motors have a lot of posts about esc noise. Apparently it's just something that happens with brushless motors when the...
  12. U

    Phantom making strange whistling noise & Bee attack video

    I can confirm it is not the motors or the air vents. I OCD, so I replaced all motors. Additionally, I temporarily taped closed the air vents near the motors. Still the same whistle. Other forums say it's the ESC switching power, but I think I don't think I'll replace those just yet.
  13. U

    Phantom making strange whistling noise & Bee attack video

    I have the same exact issue. Anyone find a fix? What is the easiest way to lubricate the P2 motors?
  14. U

    P2 Motor Spool up at shutdown

    An IMU Calibration seemed to solve the spool issue. I use left stick down. The rear left motor is still hot however. I do a lot of full forward and full up maneuvers, but turn equally. I have an aftermarket goodluckbuy gimbal. Maybe a weight balance issue?