I did some tests with my Futaba 14SG:
In GPS mode
When you power off the TX, P2 enters in FS mode ( followed by a WPT mode , as seen on OSD).
If you power on your TX , connection is established with P2 but you are not able to control P2
To take control you need to be in ATTI mode. Just after...
Pretty much the same for me
My P2 entered in failsafe mode (when facing bad signal ?) and went back to original location.
I was not able to take control of my P2 although RX/TX link was up .( according flashing code )
I've tried to turn off, turn on without success taking control.
Hope...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.