i swapped my motors whit tmotors.. but if i where going to do it again i would change to orginal ones and but t motor 9x3 cabon pops.. they are loudh but the drone are more responsive and faster using those props,...
I ment bird. I get No contact to gimball. Cant get start the motors. So i am finished buying parts for this p3p
Sent from my Le X820 using PhantomPilots mobile app
Change the riboon cable 3 times har picture. But not anymore.
So my questions Are.
I have the bord. 4 new motors.
Can i hack/mod IT to use different ESC mainboard transmitter..( i have 2 other drones usibg 2.4 GHz remotes align mr25 and echine 180 tilt motor drone... What can i buy to replace...
Downgraded rc to 1.5.8 that helped but not it says Gimbal disconnected.. So now I have to take the Gimbal apart again...
Sent from my SM-N910F using PhantomPilots mobile app
I have 2 dji p3p changed motors on one of them. Have to remotes one for the ok one and one for the one that has been repaired.. Whit both remotes.. It now reports no/weak rc signal.
Could it be the firmware on the p3p whit replaced engines? (it's not on the remote cause remote wolf fine on...
They now all fitted and Rotating the right way. Now my Gimbal are going Bananas after i put replacement after crash.
Sent from my SM-N910F using PhantomPilots mobile app
wel been there done that..
u should after my opinion at least take into account that it might not perfrom same as before...
spesially when landing.. i crashed one p3p because i was doing a landing and my dad did not tell me that he had crashed it a bit before that flight.. so when i was going to...
Reason for doing it. As I said I have one original p3p and a crashed p3p. And found little info on upgraded engines.. On the p3p.. So I whanted to test different items on the crashed drone... One engine of the orginal totally busted, and had the anitigravty v3, motors. Have to open it up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.