Hi rilot
I am learning all of that as i am going mate
I should have bought the mini, my mistake
But i do have an another issue now
After successful getting it working with the Fat Shark, used it and worked beautifully
Re-charged the battery as per normally - took about 2 hours to recharge...
Ok i have done the following
Connected the GPS cable out of EXP to the PMU V2
Disconnected the IOSD for now
Same thing
Starts with beeping
Then stops and no lights on
I connected it tot he Phantom 2 software and straight away an error came up
"Battery Error" Not DJI Intelligent Battery!"
Not...
I hadnt done that
But i did now
And as per my second message
Do i need to plug the wires i pulled out of X3 somewhere?
Or they should be left alone.....
OK, i have connected the PMU V2 to the power on the board
IOSD to its own power
Phantom start with it standard beeps, then nothing
No flashing of lights
And it doesnt respond to RC
IOSD Firmware upgraded
Hi
I just bought a Phantom 2, with few other DJI products
One of them is a PMU V2 with IOSD
When ever i connect the PMU 2 to the phantom and turn it on, it keeps beeping and flashing red
i disconnect the PMU and IOSD and it goes back to normal
i think this is happening because i am...
Hi
I just bought a Phantom V1.1
I took the battery out of the box and connected it to the charger as per instructions
But it keeps flashing green
I have had it on for few hours now and nothing has changed
Any suggestions?
i looked that up and the phantom should have a button at the bottom of it, but mine doesnt
I am not sure if i have to rebind, if it is the controller, or the unit
Hi
I just received my unit, Phantom 2
It keeps flashing yellow
Remote is fine, new batterries
I have disconnected the camera
but i cant seem to be able to get it started
help please
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.