I'm new to soldering and have had success but these new motors use a harder two piece wire that the solder does not stick to at all. It just rolls right off of the wires, luckily I put a piece of cardboard over the ESC.
I read/watched tutorials and most just say that I need to heat up the wires...
Appreciate your response.
Mostly what I'm getting from this is that it's beyond my knowledge right now.
I am still using the standard screws since I haven't gotten my prop guards (yet).
Searched all over the interwebz and no one seems to have this exact same problem.
Had a small crash (again) but I can't fix it this time.
After the crash one motor would do the jarring back and forth instead of going full on. The LEDs under were all looking fine so I figured it was the motor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.