Recent content by tanasit

There are 2 extra steps that you need to do first. 1. Go to DJI support website ( http://www.dji.com/support ) and download the driver so that your computer will recognize your Phantom. Choose the correct Phantom Version. 2. Download the NAZA assistant so that you can adjust, set, correct...

This may not be exactly what the PO looking for but I have the flight time and sound level for several props: I just want to see the differences of the flight time using different props. I chose: Phantom stock; Graupner e prop 8x5; GWS 3 blade HD-9050x3; Master Airscrew TB2318 (cut tip); APC...

Heat gun or hair dryer may help putting it back straight, but be gentle and take your time. Also remove all props and put the nuts back on then run the motors to see if the motor(s) shaft is bent by keeping your eyes on the tip of the motor. The tip should stay in place not wobbling about. Note...

http://www.ebay.com/itm/DJI-Phantom-FC4 ... 4ad331d2b3 DJI Phantom FC40 RC RTF Drone Quadcopter WiFi Camera GPS 2 UAV Spy Aerial Vision At $449.99 and free shipping, is this a good deal?

The 3 color led could also mean the IMU abnormal data. Check the receiver type, sometime the upgrade changes that to the wrong one. Good luck

Try this then, http://www.ecalc.ch/xcoptercalc.php?ecalc&lang=en

When replacing the motors, did you remove the motor's wires end from the esc board or you cut the wires and used the connectors? If you used the soldering iron to remove the wires, the contact plate may peeled off slightly and caused the motor to act funny. Most members recommended cutting the...

http://download.dji-innovations.com/dow ... ual_en.pdf

viewtopic.php?f=5&t=7029&p=56157#p56157 You may want to read the post above.

GPS does NOT require compass which basically only shows "true north". A network of 24 satellites orbits the Earth twice a day, transmitting signals back to earth. A GPS receiver locks onto signals from three or more satellites (NAZA uses 6 or more) to determine your location, using a method...

No, you don't have to use the Assistant ;) . You perform this on your TX alone. From page A5 Advance manual: 1. Set the switch S2 at the OFF position, and the switch S1 at the GPS position 2. Push the Throttle stick to the top position, and push the Pitch stick to the top position. Keep the...

Did you calibrate the TX off the computer? ;)

If this is your first time using the charger, see the manual below: http://download.dji-innovations.com/dow ... uction.pdf It looks like your pack is almost full and the flashing red led indicating that the charger is balancing the pack. Nothing wrong. Use the pack and try again.

Interesting question indeed. I think if you switch to HL mode when the compass fails, it will still fly back to home position (assuming its home point is properly set) regardless of its orientation but as soon as it gets to the 10 meter circle parameter (where it turns into CL mode), it will be...

http://www.guinnessworldrecords.com/wor ... taneously# Above is the older one, I'm still digging for the new one which I know which forum but the specific post from over 1,700 pages won't be easy.