Recent content by spiruline

  1. S

    I fried something but don't know what

    Yes, everything seems to be working fine except the rear video output. The wifi feed does work. I haven't tried the HDMI, but it seems like the problem is only in the rear connection. I was thinking about getting a new GP3+, but I am reading about all the far focusing issues and maybe is better...
  2. S

    I fried something but don't know what

    I checked with a friend's GoPro and everything worked well. So I fried the video-out in the GoPro :-(((
  3. S

    I fried something but don't know what

    I have tried with another video input and the Video TX works. So next step is to check with a different GoPro to see if the video output of the camera works. If the problem is not in the camera it could be either in the gimbal part that picks up the video signal or in the main board :-(
  4. S

    I fried something but don't know what

    Everything looks clean on the main P2 board. So hopefully I won't have to replace that, which seem like a lot of work. OI, yes, those are the wires I cross. Since the video input for the transmitter was connected to the video output of the P2, the damaging power could have gone both ways...
  5. S

    I fried something but don't know what

    Thanks Jim, Can I check those resistors without desoldering from the board? Which values should they read?
  6. S

    I fried something but don't know what

    Hello, I was installing a video transmitter on a Phanton 2 with H3-2D gimbal. Everything worked well and got a video reception until I touch by mistake the video input wire of the video transmitter with the V+ (11 volts) wire of the same transmitter while it was powered. Now I don't get any...