Recent content by Spideyman411

I guess I could have fried on of the amplifiers as the grey cable to the one antenna broke, but I did not energize the drone without the other antenna connected My understanding is that I would still see telemetry data in the app with just a single antenna. Any ideas? Guessing I would have to...

So, I soldered the reset switch to the board. I believe that resets the linkage between the controller and drone, over the 5.8G connections. I replaced both 2.4G antennas and appear to be connected to the camera board correctly. When I start everything up, I can control the drone fine, but I...

Outstanding question. First crash was flying too fast and too low, couldn’t react quick enough. Second crash, I had added prop guards, cheap ones, the drone did not fly the same, I was trying to inspect something on my roof, it to close...prop guards didn’t help at all. Third crash, bad...

Paint Thanks for the help! I have soldering irons, but not anything that can do this type of micro work. I will find a shop that can solder it on for me.

Here are some pics of the componet and the board. I have the drone apart, I can take.specific pics if needed.

Hi all, new here, first time poster. I crashed my drone pretty badly. Not sure if gimble and camera are OK, appear to be. But I broke one of the 2.4G Wifi cables and the gimbal mount. I purchased replacement parts and disassembled last night. I found out all 4 screws that hold the main board...