Recent content by sparkymarky

Download the firmware and updated via SD card

My say the same thing 1.6.8+?

Yudhistira5, I uploaded the file a zip, thanks to Killabear.

cheers, I've got it

Would it possible post a copy of the RCS file for RC zipped, as need a copy. As I couldn't recover my RC I only recovered my drone.

The 1st UART didn't work at all, I purchased another from different seller and I was given one from work.

I had to go through 3 UART devices until I found one that worked! I had same issues no response when ESC key is pressed

I had the same issues a lot of corrupted characters, I found it was UART I , I found 3rd UART fixed the issues

this what I did on drone and worked, this didn't work on RC as it stuck in bootloop at movement. I didn't use VIM 1. Reconnect the camera/modules/all of the cables to everything 2. Turn on the bird/remote, hit escape as soon as you see: Press ESC to abort autoboot in 1 seconds 3. You...

which board is that? there diagrams which where to solder on previous links

I used cp2102

Cheers, I'll will have give it a go when I get back. I'll let you know.

Do you need to short reset with gnd? Why don't you short RX and TX, on the Arduino and start putty. Press a fews keys to see if get response back from the keys you pressed.

I have managed to save my P3S, but couldn't my RC. At least I had spare Controller here. Thanks everyone.. If anyone come up solutions to get my control out of the rcS loop let me know..

Help, I thought I had solution to fix it, I don't it happen to drone. What commands I need to using Vim? As this what going on with RC? Any suggestion? bootm 0x9f420000 see rcS: applet not found below? U-Boot 1.1.4 (Mar 24 2016 - 12:37:01) MI124 DRAM: 32 MB Flash: 8 MB In: serial Out...