So I did the firmware reload first and did the calibration again using the RC software. Tried moving the X1 channel and nothing showed up.
I then unscrewed the back of the controller and used a small screwdriver to manually turn the POT that is supposed to be attached to the X1 lever. It is...
Hi all
Brand new Phantom 2 owner and I have setup the H3-2D on the aircraft however the X1 on the back of the DJ6 controller does not appear to be working. I have installed both the RC and PT2 software and confirmed the firmware is up to date on all of them. I did the calibration with the RC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.