Recent content by smino

DJI PHANTOM 3 MOTOR REINFORCEMENT MOUNTS

hi i have been getting duplicate video to my android and the camera sd card.how can i stop it being recorded on the android please.basically its taking all my memory up on the tab 3 and causing freezing...?

just got a new p3 and when flying i keep getting freezing up picture. so i thought i would clean up the tab3. when i when to delete any previous pictures i noticed that the films taken from the p3 where also on the tab3 hard drive.aswell as on the p3 sd card.so how do i stop it rrecording on the...

i am using a tab 3 and it only has wifi.so when out in a field lets say with no wifi avail.can i use my phone as a hotspot,so as to get the maps ect.i ask as This is not recommended in the manual to use near phone ect.

many thanx. it was a bit daunting to try it out on the ground and shut off straight away,this is why i asked the q's.i dont normally leave it late to rth.i usually leave plenty of time.gives me peice of mine.cheers

ok my rant is over.but firstly i did say this in another thread and did not think it was in the right thread so started another in the correct section. secondly i was getting some misleding info from some people.thirdly the part about tx intereference was nothing to do with motor cutting...

well bobmyer. i race rc buggies and have for over 30 years and never had so much interferance experianced by myself and others than with 2.4g tx.no you can get interference with 2.4 people say.well ive seen plenty of racers hit the wall at the end of the straight and breaking £500 woth of car...

if you have any samsung(t210 or above) you need to debug it in the build(allow the usb port to be open to allow unidentified items i.e. p3 and then tick the allow to use usb.this is already done on the apples n pears.

well it was todays flight and guess what,30m up pull back on throttle stick to the bottom and what happened...........

havving moved from a vision plus i have noticed that if i pull back on the throttle stick it cutts out the motors.it literall only has to be at the bottom for 1 second.(trying this without props on.so me have said that this will only happen if on the ground .and not in the air,but did want to...

yes but it turns off before i pull stick fully back.approx 2mm from the bottom.so will this be ok in flight .it is a big question as dont want to be 50ft up and the motors cut out

ok so have done all that now.working fine ,,but i have nt yet fitted props and started motors got voice saying take off. so i rev up then when i pull back on the throttle stick to just before the end point the motor stop after approx .5 to 1 second.this would cause it to turn off in flight wont...

ok all done but now a window came up on the app saying gyroscope's bias to large

hi no havent done registering the p3 or activated.just loged in on the ME on the app

hi all just upgraded froma vision plus to a p3.so i use a tab3 samsung.install dji go app.start tx then p3 then connect to tab3 via usb as per instructions.read instruction then go back to eqipment screen and that as far as it goes.what happens next.?????not able to go passed this point?????