Update: I have it powered on and gimbal attached and as I move the gimbal around with my hand it reacts but very very underpowered like it's not receiving enough power. It also beeps when I try to calibrate it and the beeps come from the motors so I know it's getting a signal. What could cause...
Also, the camera gets kinda warm now, i don't know if it did that before. I'm just saying that because it shows that the camera is getting power
Sent from my iPhone using PhantomPilots mobile app
Hello,
So I recently crashed my standard from about 10 feet. The drone itself is fine except the gimbal roll motor broke. I replaced the motor, everything looks fine. I start up the drone and the gimbal light flashes but the gimbal doesn't move. The Go app says "gimbal gyroscope error" I have...
Hello, i just replaced a motor in my gimbal but now that I put everything back together it doesn't work, the red and green lights come on but the gimbal doesn't move. Please help
Sent from my iPhone using PhantomPilots mobile app
I just took apart my gimbal to replace a motor and now I'm trying to fit the ribbon cables back in, the black ribbon cable fits in perfect except for the largest one going into the control board, it just won't go in. Also the brown ribbons from the motors won't fit into their sockets either...
No roll motor available, no one seems to have a roll motor, my solution is to use a pitch motor, cut down the shaft and replace
Sent from my iPhone using PhantomPilots mobile app
Hello,
I just crashed my phantom 3 standard and the ribbon cable attached to the motor, not the black ribbon cable attached to all motors, tore off and I can't find a new note anywhere. What can I do? I can't afford an entire new gimbal.
Sent from my iPhone using PhantomPilots mobile app
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.