Hello All,
After updating to 3.06 last night i did an advanced IMU cal. I shouldnt have touched it (should have done basic only) but for some reason i did.
The process was very painful, the calibration just did not want to progress to the end. I had it running several times, the last time it...
It appears I am also plagued by the tilt. It became apparent when I removed fisheye effect from an image.
The horizon was sloped. My copter never crashed. Im thinking about applying the fix after some thorough reading.
You will need to install the dji drivers as well. Not only the software assistant. Download it from dji. It will work then. My assistant also did nothing until i installed the driver.
Second, for the controller you will need to download RC Assistant software.
I have seen various night recordings here. What i do not like about them is the light cast by the red front LEDs. Will this solution prevent that from happening?
Re: Pleading for help from local pilots (Central Massachuset
Djmt i hope you managed to find your p2v+. Do you mind sharing the circumstances of the mishap?
@MalPV2
About 20km horizontally from the nearest runway. Nearest GND-3000 CTR boundary (which I may not enter ofcourse) is much closer though, 7km.
In the image I attached you can see I would like to fly under a "connected" CTR which starts at 1200ft. Its allowed. Im just thinking...what if...
I plan to fly well beneath a CTR which starts at 1200ft.
Under no circumstance can i exceed that altitude. Busy airport approach/ departure above 1200.
No problem if the phantom behaves. But now im thinking fly-aways.
Will limiting the phantom max altitude to say 800ft keep it below 800 even...
Prior to a flight some time ago i noticed the camera response to my input on my phone was inverted. After a reset of the phantom the response was as it should be. Anyone else observed this glitch?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.