Recent content by SkyCamFLA

  1. SkyCamFLA

    Movement inside P3 controller

    Thanks Bob...I don't know why I thought it could be easy!
  2. SkyCamFLA

    Movement inside P3 controller

    I hear and feel movement inside my P3 controller. It sounds and feels like something (maybe the battery) had double side tape on it and has broken loose. Has anyone else had a similar experience and is there a way to open it up. It doesn't seem to have the screws like my P2 controller had...
  3. SkyCamFLA

    T-Motor MN2214 Bearing

    Hello, Anyone know the bearing size for the T-Motor MN2214 or which vendor might have a replacement set? Thanks!
  4. SkyCamFLA

    Zenmuse H3-2D Level Issue

    Not sure if there is a thread on this already, but I'm constantly having issues getting my Zenmuse mount to be level. In post I have to rotate images between 5 and 10 degrees to the left. I've Googled and found similar issues, but no real solution. I try to boot up on level surface and stay...
  5. SkyCamFLA

    Upgrade board = 2 bad Phantoms

    Thanks for the update and info MediaGuy...once I get mine back up, and suggestions on the bad drift issue when doing hover rotations? Other than that, 3.16 was OK for me. Thanks!
  6. SkyCamFLA

    Upgrade board = 2 bad Phantoms

    Hey Darrell, I had my upgrade board go bad as well, though I think it was partially my fault. Once I installed my Zenmuse and 3.16 I was having some pretty good drift issues when doing spins (left/right moves on the left joystick) I decided to downgrade to 3.12 and when I did, it also showed...
  7. SkyCamFLA

    Calibrating IMU

    Hi all, Is there any way to calibrate the IMU without the software? I've heard some horror stories about the 3.16 with the newer units. In any case, I haven't been able to get mine to talk to my PC anyway. When I try to plug in the USB, the computer says it can't recognize the device...