I've been looking at those same amps but I remember reading you need to also buy attenuators to put inline before the amps so the signal feeding them is not too high. I'm guessing you haven't had any more issues with this setup after you mounted the amps off of the controller?
Would a 5.8ghz amplifier on the remote alone help this? Or does there have to be an amp on the P3S itself as well?
I may start a new thread for this discussion.
Sent from my iPhone using Tapatalk
I've been using my P3S for about two weeks with the DBSmod...great improvement over stock.
Anyways, whenever I lose signal it is always the RC signal, never the video...is that the same with you guys? Most of the time the RC signal is lost when I still have 75% video.
Yes it is the 22-24160 (the deep one), so far I love it. Cutting all of the foam wasn't terrible but it definitely took me about 2 hours or better to lay it all out and cut it up. The foam is pre-cut in small squares in attempt to make it easier to layout but in reality they don't all tear off...
Testing my deep case now. Leaving the bottom foam in gets it just about flush with the top of the bottom half of the case with the props on. The egg crate type foam in the top just puts a little pressure on it when its closed.
...time to start laying out the accessories
I should have the MCM 22" Deep case waiting at my doorstep when I get home this evening, I went for the deep model to hopefully allow me to have foam on top and bottom with the props on...I'll let you know how it turns out.
22" Black Tactical Weatherproof Equipment Case - Deep | 22-24160...
Looks good Mandalay, I can't keep my DBS attached or fit an iPad in my hard case backpack (the DJI one)...let alone keep the props attached.
There's one review on MCM's site saying that box won't fit a P3S without smashing the top, is yours tight on top?
22" Black Tactical Weatherproof...
jrsweger,
I don't have much experience with antenna's but I would like to get a terminator like you suggested. How do you determine the polarity of the terminator and what polarity do our kits require for protection?
EDIT
I see what you mean by polarity now, its not in reference to the...
I ended up getting the ITELite ITE-DBS01_V.1, here are some pictures of what comes with it (since I couldn't find anything other than the one picture on their website when I was researching it).
I ended up making my own mounting bracket so I could mess with the angle of the antenna, the...
Here's mine, just finished it less than an hour ago. This is the ITE-DBS01_V.1 from ITELite's website but I made my own mount on the 3D printer today at work so I could pitch the antenna up or down. Turned out pretty good.
No he bought them separately.
Phantom 3 STANDARD antenna upgrade | Page 16 | DJI Phantom Forum
Post #314 of the above thread he says where he ordered from.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.