Recent content by scotthan

  1. scotthan

    Replaced all 4 motors on P2 - not working

    After i verified which of the original motors was stuttering, I swapped the motors diagonally. The stutter stayed with the motor not the ESC board location. The new motor arrives today or tomorrow. When I replace it, if it still has an issue, I'm declaring witchcraft on this craft and burning...
  2. scotthan

    Replaced all 4 motors on P2 - not working

    Makes sense. Thanks for helping me work through this. I just ordered a 2212 to replace the failed one. I'll be putting up the 2312's on eBay in a minute. Hopefully others contemplating an upgrade will double check the things I've shown in this thread and avoid the pain I experienced.
  3. scotthan

    Replaced all 4 motors on P2 - not working

    Here's what was under each sticker .... ..... the different versions of boards are HARDWARE differences, correct? If it were simply firmware, then you'd just have to update firmware to get 2312's to work, correct?
  4. scotthan

    Replaced all 4 motors on P2 - not working

    They are all marked 2.1. This was a new from factory drone purchased 18 months ago. I also noticed that it appears there's a label on top of a label. I'm going to peel it off and see what it says beneath. This is the first time this bird has been cracked open. Could someone at DJI have simply...
  5. scotthan

    Replaced all 4 motors on P2 - not working

    As I said before, I just tacked it together to make sure it worked. I have heat shrink tube. What's the point of wrapping it all up if I haven't tested it? Your tone came of a little condescending and rude. I realize I'm new here and you might have glanced over all the details in my response...
  6. scotthan

    Replaced all 4 motors on P2 - not working

    No, I just always make sure everything works before I seal everything up. I just put one of the old motors back in and it worked fine (Video in the link), so yes, looks like ESC boards are needed. However, it's frustrating as the "manual" with the motor shows my 2.1 boards should work with these...
  7. scotthan

    Replaced all 4 motors on P2 - not working

    Hello, I have a Phantom 2 Vision. One of the motors started stuttering so I ordered 4 new 2312 motors. I checked that I have the v2.1 ESC boards. I assumed it would be a simple replacement. I replaced each one individually, checking that wires were correct and CW and CCW were in the correct...
  8. DJI_Motor

    DJI_Motor

    Pic of ESC 2.1 board with 2312 motor on Phantom 2