Hi, I've just set up my phantom 2 (Not Vision), used the Phantom 2 Assistant Software v1.08 and switched to Nasam and enabled the Control Mode Switch so I could use GPS and GPS Atti.
The reason I've switched to this was due to problems locating satellites. However I still can't get satellites...
I recently crashed the phantom into some water, not the first time but this time one of the motors is failing. When I power up the following two things happen, see video links below. Very occasionally it starts up ok, motors all fine. Also the red LEDs are on permanently on the affected motor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.