Recent content by SamaraMedia

  1. S

    Firmware Update 01.05.0300

    Using new iPad Pro (happened with original iPad Air or mini2), temperatures were 20˚ warmer
  2. S

    Firmware Update 01.05.0300

    I went out and flew again yesterday with no issues. Tried to recreate the problem for 15 minutes of steady gimbal movement and drone maneuvers with no flips...
  3. S

    Firmware Update 01.05.0300

    Flew on Sunday after updating firmware (STUPID!!!) and had the gimbal flip happen to me. Flew out to a lighthouse to see the frozen water around it and panned dow as I approached, stopped over it with camera directly down and stopped recording. Began recording again and pulled back same...
  4. S

    How can these guys get away with this?

    I don't know if having your Part 107 will help since the FAA has included autonomous flight as non-waivable: Not All Of The Part 107 Regulations Can Be Waived. Here is a list of things that CANNOT be waived under 107: Autonomous Operations– No Part 107 remote pilot in the loop.
  5. S

    P4p hdmi module

    What resolution will the module output, 720p or 1080p? Will the firmware upgrade make it 1080p like the P4P+? Thanks, John
  6. S

    Verizon hiring drone pilots

    Be interesting to see where they can fly in Houston since from what I've heard the FAA put into effect a drone ban 34.5 miles around the stadium. Brilliant move... Plus isn't shooting from a moving vehicle (other than a boat is one exception) a no-no with the FAA unless you have a waiver?
  7. S

    CTDOT to Test (UAV) for Bridge Inspection

    Here's a link to a story that ran in the Hartford Courant. It says they used an Align hexacopter - DOT Takes To The Air To Inspect New London Bridge
  8. S

    Phantom 2 LED/ESC one light out

    I recently had a flyaway while flying FPV so not sure of the exact cause. Wasn't very far away, high or fast but bent an arm (thus the need for the new shell) and broke my Zenmuse H3-2D mount. I just finished transferring all electronics from original P2 to new shell. I replaced one motor (CW)...