I initiale couldnot set home Point either. By searching the web I found the drone has to hover at least 3-4 ft in the air.
So I initiate automatic lift off, once in the air at the 4 ft hovering altitude I set the home point, works every time.
My P3 showed a continious green/yellow light above the camera after 20 mins or so, waited 5 more to be sure, switched off and checked log file, it says succes and 5-6 times abort because firmware is the same as the one installed.
Conclusion, once the lights stop blinking the update is done...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.