Recent content by rombzg

Ok, I tested that. I checked my 2 batteries and the P2 connectors. In my RC the motors start in ATTI mode, but not in GPS. I removed the battery, checked again, and miracle the motors start ! I don't understand why, but for test the good running I flying during 5-10min and It was ok… Thank you...

Yes, my P2 is open, I checked the socket I looked if it is not connected upside down, but its impossible to bad connect. When I closed the top of P2, cable don't move. The problem come from elsewhere ?

The GPS cable is ok, I checked the cable connexion and P2 green blinking read to flying. The P2 is new, just 1 fly without gimbal, after installed gimbal on the P2 is ok, blinking green. Updated the remote, crash update and problem… What is the yellow power led color on the remote ? I don't...

1. The remote is paired to the P2, le led under the P2 is green. 2. Switch to an other battery and same problem. 3. The P2 is ready to fly, the led of the P2 is green. It's just the remote, before upgrade it was ok, but not now. The upgrade crash the first time, I updated in loader mode and...

On the video its an older controller, I have the NDJ6. The battery is charging, but it can't start the motors… The power led is yellow/orange and the 4 others led is green.

Hi, I have a problem with my remote controller (NDJ6) after upgrading firmware, the power led switch to yellow. I tested to calibrate my controller but color not change to green like before upgrade… With this problem, I can't controlle my Phantom 2… :/ How to do ? (same problem:)