Recent content by rockandice

Re: FS: Simensays Foldable Landing Gear for DJI Phantom REDU PM sent.

Thank you Ian and everyone who helped out with the V5. I am using it on my 14sg, and it is AMAZING! Great work!

I am so excited to see what you come up with! Keep up the great work!

I had a similar issue as well. I tracked my problem down to shooting both photo and video mode. Upon further investigation, when I was shooting just in continuous photo mode, the screen would blank out on my FPV for a second, then return until the next shot (at 5 second interval). Shooting...

Well, here we go! I think it is time we all get Organized, start to send letters to Park Service Superintendents, and become vocal to our elected officials. I would much rather have a Permit process in place that would limit areas and times Ariel Cameras (not drones) can be used, and specific...

Add me to the list as well please. I am SLC Utah. I am still on 1.8 firmware, with Futaba 14sg controller. I plan to get detailed readings, re read this forum to test some of the ideas, and let people know about results. I appreciate all the input everyone has added, thank you.

Thank you dave, after I posted I did an internet search and found the same information. I will be trying this out tomorrow. Thanks again for your help!

@ davemcm: could you elaborate on what a power (lc)filter is? @ fangscpo: could you post a picture of what you did with the duct tape? I think that each of you have options that could help me out with my FPV issues, I just need a bit more clarification of your solutions. Thank you,

I am hoping you all can help with my issue. I have done the installation and all appears correct. The Naza software show the sticks all work, and all is good to go. I cant get my phantom to start up, using the normal startup. What am I forgetting to do, or is the startup something new...

I am hoping you all can help with my issue. I have done the installation and all appears correct. The Naza software show the sticks all work, and all is good to go. I cant get my phantom to start up, using the normal startup. What am I forgetting to do, or is the startup something new...