Recent content by Robert Teegarden

  1. R

    Gimbal Repair & Calibration Error

    Got it in the air briefly last night. Right rear motor sounds funny and stopped MUCH quicker than the other three when is landed. Could be debris, so I'll try to blow it out and see if that fixes it. If not, then a new rotor is in order.
  2. R

    Gimbal Repair & Calibration Error

    Rod - Thanks for the tip! I pulled the top shell off to see if there was a connection issue and indeed, there was. The orange wire on the compass connector had been cut, presumably by the crash! I soldered it back together, fired it up and calibrated the compass with no problems! It even fixed...
  3. R

    Gimbal Repair & Calibration Error

    I can see the image from the camera, yes. The IMU adjustments are normal - not near them now so I forget the exact reads. I can change camera settings. Where would the connections be, under the shell?
  4. R

    Gimbal Repair & Calibration Error

    Hi All, Been lurking here for several months but just recently came across an issue that I can't resolve with researching the existing posts. Long story short; repaired my drone last night after a crash that snapped the camera off the yaw arm. Replaced the yaw arm, gimbal motor and the...