Recent content by robelander

yup did that... no luck.

Any pics of camera board #3?

JDot, I am guessing I burnt out the camera board #3 It willnot even connect to my wifi. I was thinking it was the wifi module but now I see your theory. This sucks!!! I need this for work :( DJI was no help.

Ok, never had the problem before using Iphone 4S. Developed this problem just recently after not using my PV2 for the past 3 weeks. I tried re calibrating the PV2 did not fix the freezing/dropped video signal. I deleted the App and re installed it in my IPhone 4S and it seems to be fine. My...

I am experiencing the same issue of not only pics freezing but a serious delay in video transmission. I will descend and the pic still shows me at 500 ft. Then 30 sec later it will show the descend. Weird. I shut everything down and rebooted my IPhone. I am going to try it again this morning...

Thanks for the help. Happy belated St Pat's. It's lunchtime, time for a pint.

Ok I feel I am missing something here. I cannot find the app on my Ipad. The only thing I find is a German DJI app. I have it on my IPhone which I use but I would like to see it on the Ipad. Help anyone?? Thanks

Ok just curious, does anybody know if the flight data displayed (telemetry) on the viewing device (iphone ect) is measuring from sea level? My attitude data reads 11 ft while sitting on the ground. I have not tried re calibrating it yet, but will do the next warm day (which seems like never).

Ok What about if you have a Vision (Tx 5.8) and replace the camera with a Zenuse gimbal using a GoPro? Goodluck buy has the USB cable for the gopro and they also sell the same cable used on the vision camera (3mm jack). The only change I see is the plug that plugs onto the circuit board in...

You must have found my Vision. LOL

Anybody traveling on an airplane with their P2 or P2 Vision? Do they allow carry on? I would imagine that you have to pack your battery in your suitcase. Any info would be appreciated. Thanks

AH HAH!! Figures a day after my original post the software for RC Assist comes out for the transmitter (at least under Phantom Vision support downloads). See everybody DJI pulls through... don't be so hard on them (oh yeah by the way I still never heard back from them since I emailed them 5...

So I plugged the Phantom in to the laptop and have the assist software running. Does anybody know if the transmitter can be calibrated through this method??? I went to the tab that deals with the transmitter and it seems to work. The USB in the transmitter (splitting the case open) does not...

Sounds like we are in the same boat to no where. LOL I flew my phantom with only the firmware upgrade to the quad. It seems to work fine without calibrating the transmitter. I did check it by connecting the quad via the usb cable and turning on my transmitter. It will show the stick movement...

I just purchased a Phantom Vision and flew it with no problems. I wanted to upgrade the firm ware and did so via the Assist software (downloaded driver and Assist software). The Phantom Vision's firmware was upgraded no problem but it said to re-calibrate the transmitter via the Assist...