Recent content by rmarler

I will update APP to 2.7.2 , for android, thanks for your help

ok, thanks , I am using android

Thanks for the reply, I am running APP 2.7.1, A/C 1.7.60, and RC 1.5.80, when i went to "ME" and settings as you mentioned, but i did not see camera view. maybe I need to update firmware to latest version to see the " Camera Quick View Launch" thanks for your help. rm.

How do you set the " Camera Quick View Launch" as mentioned by several people on previous posts. I can not find it in the on the latest firmware. Any help would be appreciated. rm.

Question, How do you set the "camera Quick view Launch" that has been mentioned in the above posts on this thread? thanks for any help. rickm.

I had the same experience after upgrading the same as you. I received the message of "Disconnected" did not get video on RC to come back. I landed the P3, shut off power, removed battery and problem went away when i flew a few minutes later, Flew last night and no problems on that flight.

Douglas Wyoming

Did you get a txt file message on the sd card after the firmware update on the P3 stating "Success" after the update ? and also from the controller showing "success" ? it will be on the sd card with the bin file.

Go to you tube and search for phantom firmware upgrades, complete videos on how to do it, watch it first and it will make your job much easier.

AbsPapa, I'm a newbie but i will try and help you out. You failed to say what the problems are in your post. If you up graded the firm ware to 1.2.6 and got a successful .txt from both you Phantom and also the controller, then you need to calibrate your IMU while it is COLD. Once you...

Just finished re calibration of COLD IMU, Re calibrated Gimbal also, Instant on now, with no delayed warm up time. Thanks everyone for you help from a newbie.

set Phanton over air conditioner vent to cool off this morning, calibrating now. Thanks. rm

I will do the cold IMU calibration, as I calibrated yesterday following the firm ware up date, so i imagine the IMU was already hot. Thanks for the fast reply to my question. RM

I completed the firm ware 1.2.6 yesterday, every thing went fine. Re calibrated IMU and compass. I have noticed that the warmup time is longer now. I still have the .bin file on the sd card in the phanton. Has any one else notice the increased warm up time on your updated firm ware...

Question on up date after reading PDF instructions with 1.2.6, update. After reading item 2 below, Do you have to have the air craft powered on for the camera to make this beeping sound, or will it get its needed power from just having the battery in place on the P3. It does not say any...