Recent content by RJay

Thanks for the nice video... Actually... I have replace my p3 shell 3 times already... its not very difficult... you have to take care when tightening the screws... Just enough force to tighten them...

56...P3Adv only

I am facing the same problem after upgrading firmware... however... I ve fix it by tips shown in the video

I upgrade both firmware of phantom 3 and rc... Successful... But then rc cannot connect to drone... Please help

I was flying my P3A... after about 18 minutes... I got a warning on the device... warning... battery overheated... I land the drone... pull out the battery and feel hot and it swelling a little. I let it cool down ... and the swelling gone ... Is it safe to use the battery in flight again ...

Me too, after updating dji go app... the app immediately cash when I open What to do now.... cannot fly my drone

I have upgrade my aircraft to the latest firmware , but when I check the version in the dji go app...its stated as version 1.9.60+. Anybody get the same reasult or diffrent.

Msinger... I found this motor at online dealer... Is this motor suitable. The actual motor on my p3A has nothing written such information on it.

The old motor model is 2312/960kv... am I right....

Hi msinger...can I replace the old motors on my P3A with new motors...

Hi...Can I replace my P3 old motor with the new motor. Any issue...

Any ideas where I can get that parts msinger

Hi... anybody can help me what is the name of the part inside the P3 shell thats mounts the MC board. This parts has 4 studs that hold the MC... Mine. 2 studs broken. So the MC a bit shacky inside the body...

I get P4 when P5 is comming out