Recent content by rixlumb

  1. Front-RC-relays

    Front-RC-relays

  2. Rear-smoke Gens

    Rear-smoke Gens

  3. Stbd-view

    Stbd-view

  4. R

    Gimbal guard for wide landing gear?

    Why would you need a gimbal guard? ...using longer wider legs for skids.I used a case to fit the final product.....aluminium tall square lockable case, fitted sponge where neccessary. I Only had a bad drop down crash when one of my 'additions' namely a Canbus bypass to control my Walkera 2D...
  5. R

    Crashed P3A into wall today.

    ...And i thought there were 4 directions you could fly without actually turning. Need practice on a SIM. before practice in a BIGGER area with person/building not under operator control... as is specified in rules!! And possibly go to 'Specsavers' ...
  6. R

    "New" refurb, in beginner mode, flyaway and crash

    Has it been established that the pilot was not manically switching between GPS and ATTI. if not check the freeking remote.?
  7. R

    "New" refurb, in beginner mode, flyaway and crash

    I'm intrigued as to why it looks like the pilot continually switching from GPS to Atti and back. I noticed on my P2 that the remotes switches S1 and 2 are very sensitive. I.e they do not need to be moved fully to the next position before that mode is triggered. I'm fact when my S1&S2 are both...
  8. R

    new user with some simple questions - I hope

    Height...250. -800 metres??? Surely mean distance. Height limited to 120m if yr sensible
  9. R

    Walkera G-2D gimbal settings on phantom 2

    Hi, I was very interested to find out that the signal from the antenna board/receiver was an Sbus one, having the same coloured wires as a normal servo control leads threw me as I was trying to figure out all the connections to the orange phantom controller. It looks like this would be the only...
  10. R

    Walkera G-2D gimbal settings on phantom 2

    I just drilled two small holes 15mm back from the edge of the cutout designed for the 3D zenmuse. To get the C.O.G correct , I placed P2 on a flat kitchen scale and moved the gimbal & mounted camera back and forth + a piece of sticky 2 sided foam, so the P2 looked balanced and evenly off the...