Recent content by Rich007

Lightbridge Charging DC 'Plug' size & where to purchase Hello All Has anybody got hold of a replacement DC 'plug' or lead with a plug which can be used as a replacement to charge the Lightbridge station (do not want to cut up original lead). As I normally charge in the ''field' from portable...

I'm using a Turnigy 4x6S 400W Lithium Polymer Battery Charger. I know is expensive but use it to charge in the 'field' as it is 12v input, so if you want to use on mains power you would also require a 12v power supply. I always prefer to charge individual batteries with separate outputs just in...

Have a look at:- http://www.rcgroups.com/forums/showthre ... 3&page=126 Has got a lot about the new beta Lightbridge software as well. Regards Rich Where are you?

Thanks sar104 Thought it was strange to get no paperwork at all in the boxes. Have today had it temporary connected to phantom 2. Used the video on dji web site and manual download. Both could do with a make over to make clear. But have got it going on the table. Picture quality A1, bit of lag...

Got my lightbridge yesterday, i'm in the uk. Two boxes turned up, one with the main bits in and a extra box with the holder for a phone, lightbridge to rc holder, the flexible hdmi cable to gopro hero for the phantom 2 and a few screws . The one thing I did not get was any paperwork in the boxes...

My Futaba was bought in the UK from Kings Lynn models. I took the back off to have a look before ordering the centre spring kit. To my surprise all I had to do was remove a plastic plate about 1" sq and the lever that creates the clicks. Remove the screws and have a look, before ordering self...

I got my extra set from Kings Lynn Model Shop but was holiday near, so did not have to pay for p&p £10.90 for 2 Regards Rich

Hi all I bought a Futaba 14SG from Kings Lynn Model Shop in the UK. Was about to send of for a 'spring return kit', but though I should take the back off the 14SG to have a look. To my surprise all I had to do was remove 1.5" sq flat bit of plastic, by removing three screws and a ''metal clip'...

Hello All I bought a couple of sets of the Blue Props on Friday in the UK, looks like the red ones they had are out of stock. They come in original DJI packaging. http://www.kingslynnmodelshop.co.uk/ Look up :- DJI Phantom 2 Vision Props Do not know how to add long web addresses? Regards Rich

If you buy a Lightbridge will the HDMI signal pass through the new Gimbal without the external HDMI cable. Regards Rich

Can I as a couple of Questions:- Which country do you live in How much insurance have you got, even if you have it would not be valid with the irresponsible flying in the small print I have been hit by a model airplane when I was at school, the plastic propeller did quite a lot of damage to...

http://www.ebay.co.uk/itm/DJI-Phantom-2 ... 1270203467

Has anybody taken a DJI Phantom 2 Mains charger to bits and had a look at the charger circuit and done any test to check charge current and voltage during the charging of a battery from empty to full charge? Also has anybody taken a Phantom 2 Battery to bits and had a look at the circuit...

Hello All Nice to see quite a few Radio Amateurs on the forum. I used to do a lot of Amateur Television (ATV), I was the first repeater keeper to have a 2.4GHz ATV repeater in the UK. Due to work commitments have not done much in the last 5 years. But still make it to the local amateur radio...

Thanks Ken Have spent hours reading and looking at the videos. Looks very nice, shame they have not got it under the $1000. But might buy one once the full spec and manual comes out. Regards Richard