Recent content by rcray

I recently sold my Phantom to a friend. He crashed it and we now get an ACCELLERATION(g) Error on the Y axis. I have tried bumping it around and Advanced calibration. We are at 3.16 of the firmware. Also, occasionally we get the IMU temp warning. But not always. Any suggestions on the Acc...

My issue has been resolved. Not too sure how, however. I recalibrated IMU, then went outside and calibrated the compass and it now works. Will try to fly next and report.

I have experienced the same problem. I see that nobody has responded to your post. Can someone help us? :(

Hello, CSSFLY. I have found several Youtube videos which seem pretty complete. This seems to be the best one. http://www.youtube.com/watch?v=ck3tu-4UVgg I have been able to follow it after watching several times. This was my first attempt at programming a RX. I have been able to execute every...

I have been watching several YouTube videos on configuring Futaba RX and TX for phantom and F550. Question: The IOC switch in on the left of the stock phantom TX and the GPS, ATTI, ATTI switch is on the right. In all of the videos, they have them reversed. They had OIC on SG and Mode function...

Thanks Racklefratz. Here are some comparisons of weights: 1.3GHz 300mW Transmitter with antennae = 30 grams GoPro Hero 3 = 76 Grams Water Proof case= 87.5 grams Alternate Mount of my design=46 grams Thus, the load would be between 172 grams and 193 grams. Weight is not so much of a problem as...

Has anyone had experience with using a 1.3 ghz TX for FVP on the phantom? It requires 12V, but I am concerned that the 12V wires coming through the bottom of the craft might be too small to power the TX. I am looking at a 1.3 ghz, 300 mw tX. Thanks

Re: DJI Naza-M 2.12 / Firmware 3.12-Paramerters ****!! I imported the parameters from the website, unzipped it and NOW IT IS WORSE. It is basically flying as if no GPS is available. Also, I am not getting the amber lights flasing indicating GPS Satelites. I only get two green flashes. I have...

No, I did not. I'll try that. Thanks

Re: DJI Naza-M 2.12 / Firmware 3.12-performance I updated to Assistant version 2.12 and firmware 3.12 yesterday. The peformance of my Phantom is worse. Specifically, Before upgrade the altitude was holding steady withing a foot or less, and laterally withing a meter. Now I am getting vertical...

I had the same registration issues. I finally got someone at DJI China to send me a user name and password.

What version of the software has the “Receiver Advanced Protection”?

Re: New Camera for FPV? Update I was just reviewing it on the JVC website. One problem will probably that the access to the USP port is under the Battery cover.

I had already determined that the aux power wires were 11.1 volts. I had seen the Castle BEC. Looks like that is the way to go.

Has anyone had any experience with the new JVC Adixxion camera? Check it out at: http://jvc.net/gc-xa1_s/index_en.php Comes with 1/4" base tripod mount, 1.5" LCD Screen, Lense covers, is water resistant without a special case, Full HD 1920 x 1080 resolution at 30 fps and 1280 x 720 res at 60...