No. I was trying to update firmware with sd card..never got it to finish. Thats when the board issue came into play. Since the board is needed for both, I’ll have to find one. This board issue with the p3 pro is very wide spread. You would think dji would get involved with that many people with...
I took p3 pro to drone repair shop and they said the board for the camera was bad. They tried to find used board that would work out of their surplus...no luck. Can’t see spending 350 for new camera assembly. Will try to find used camera and install. They said the board overheated and failed...
The camera issues started with...when taking first picture, it would never finish image. I could reset drone and start over with first picture before leaving ground and was able to continue taking shots with no issues until next flight. Finally the new problem was “image not transmitting” and...
When I go to take off with the phantom 2, it goes up about 5 ft and starts deceleration. It is forced back down to ground due to not maintaining prop speed and is flashing red. I have tried another transmitter. Any ideas? Thanks in advance.
hello..I own a phantom 2 with a go pro camera and like the image quality but not flexibility of camera control. I bought a phantom 3 pro and like the transmission improvement but am having problem with “ image not transmitting “. I see were this is a common problem. Every thing works back to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.