Recent content by RCeeWee

  1. R

    PROJECT Phantom6

    Update from Denmark. Best you see the video :)
  2. R

    PROJECT Phantom6

    BTW - just realised that i might get the problem with the props not being self-tightening. Can recommend some props I can use for future where i can just put on a bolt? I will for sure use these first, but some to fit all motors could be good. Thanks. Or perhaps i should cut of the bolt-part of...
  3. R

    PROJECT Phantom6

    604Phantom - just now saw that I am actually to swap motors. Had intended to just swap the Servo wires to make all motors spin the other direction. But that would give me the problem that the props would not self-tighten after the operation. Guess the only solution to that is the actual motor...
  4. R

    PROJECT Phantom6

    HAAAHAAAA...i hope you are right...would be too funny (and embarrasing ). When i get home monday i will do the swap I almost lost hope by now...but i might be back
  5. R

    PROJECT Phantom6

    Hi all - i managed to shoot a video. Please have a look. Any advice would be appreciated.
  6. R

    PROJECT Phantom6

    All assembled - IMU calibrated. Powers on fine and rotations a correct... But no lift off at all...just fast spinning and motors work...but no lift off....
  7. R

    PROJECT Phantom6

    Had good progress today. And most important: the DJI Naza software fully accepted switching to hexacopter. All motors tested and spinning in the right directions...
  8. R

    PROJECT Phantom6

    Hi rebelyellNC - there are no dumb questions. :) The F550 has a Power Distribution Board build in - that is what i expect to use. See pictures...then it could start to make sense? I spent a lot of time today extending motor wires and motor control cables. Was fun. Sunday will give a bit more...
  9. R

    PROJECT Phantom6

    Operation started - Cruicial part of knowing whether "this" Naza will take 6 motors is still to be checked out...
  10. R

    PROJECT Phantom6

    I have ordered the DJI F550 frame, two 2212-920 motors and two FC40 ESCs. That should get me started. Once I have finished my current FPV 250 Race Quad I will give it a go to convert my FC40 - I am a bit tired of the small battery space and the rather bad handling of gimbal and GoPro...so, will...
  11. R

    PROJECT Phantom6

    Hi - what was the end of this adventure? I am looking into converting my FC40 into a Hexacopter as well...did it work out fine at the end?