Recent content by Raymond.HK

Re: New Plug-N-Play 3DPower Gimbal (aka Taco Supreme) I am worried since no other persons seem to have posted similar frustrations. Or is it a specific issue related to my craft. I unload the 4 prop guards to reduce weight but the same falling down situation does not improve. Raymond

Re: New Plug-N-Play 3DPower Gimbal (aka Taco Supreme) Dear all, I have used the original version of 3DPower Gimbal and have also bought direct plug/play upgrade, so that I did not have to open the P2V case to modify F2 at all. I previously had but no longer have problem with the SimplyBGC GUI...

Is it not the best way to check if the camera is horizontal is actually to power up P2V (but P2V original white cable to plug to camera, not the Gimbal Controller) and look at the smartpone video via wifi. Then calibrate the Gimbal Controller (connected by USB to computer) by reset, GUI etc...

I have already set the gain to 0 in DJI Assistant Software v2.0. I think I have figured out how reduce some of the vibrations. 1. The camera must be balanced or roughly balanced before power-up. I have talked to Mr. Mak of Taco and he confirms that the motor power is small and could not offset...

Tizzl10 & Richard, I am also trying to setup the existing 3DPower Gimbal (not their latest plug & play) with direct power upgrade kit. I also get a pitch control cable from Taco but when I connect to the Gimbal through the original P2V cable (which is supposed to connect to the DJI camera...

Dear DKDarkness, Thanks for the link. Strange that I could not download the link from my home computer last night but I can download from my office computer this morning. Would try to play around the GuI to adjust the shaky Gimbal. What are the appropriate parameter settings within the GUI ...

Dear all 3DPower Gimbal owners, I just try to setup the old/existing version of 3DPower Gimbal but the Roll trembles/shakes a lot when I try to move to side by side limits. Could I reduce the shaking by adjusting SimpleBGC GUI ? but I could not find a valid download of GUI2.2b2. Even the...

Re: The Phantom 2 Vision main controller firmware has been u Got my frustration yesterday night trying to upgrade but the firmware was not upgrade at all. Still got firmare v1.08. Would try to re-do the firmware upgrading again tonight. I notice that DJI have different upgrades for Naza-M...

"Find My Phantom" in DJI Apps is not accurate, particularly when you really have to use it. So always check in advance before and after each use how far its map location will be different from the actual spot. In my last time flyaway, the P2V travelled about 620 m (measured from Google Earth)...

Whether in GPS or Att mode, there is a (low) limit how you could pitch to move forward at low altitude (say 1 to 2 m off ground). I crashed my P2V (already calibrated in GPS mode) to the sandy ground the 1st day I practised it when I just lifted it up at about 2m high. Moved the forward stick...

Re: New Plug-N-Play 3DPower Gimbal (aka Taco Supreme) I have ordered 3DPower plus new egg shell and dampers on 21 March and this morning I received their parcel (as I am living in Hong Kong). Yesterday night, I also ordered their just released direct power upgrade kit. See whether I could...

My order is 795 but I would soon go on a pleasure trip on 1st May . To get a gimbal anyway (stock camera footage is almost useless if there is mild wind, even after wrap stablization by After Effect), I have ordered 3DPower on 21 March. Received the gimbal this morning (as I am living in Hong...

Dear P2VFlyer, Could the location (about 250m) be somewhere here:- Raymond