Recent content by r1fmc

No, I'm not sure how to do that?

After making permanent connections to the ESC and putting the P2 back together, on start up exactly the same problem has reappeared!! I think I'm going to have to replace the ESC & motor.....again. I didn't anticipate having this much hassle & extra cost with a new P2 that's hardly flown.

Although I ran the faulty motor for less than a minute, could the resistance on the motor have damaged the ESC in any way? I hope it's not an intermittent fault, I wouldn't like it to manifest itself whilst airborne with all my kit on board! Cheers...

I've just been running all the motors for less than a minute to test the voltage going through the faulty motor. When I stopped the motors I noticed that the faulty motor was quite warm in comparison to the other three, suggesting the problem may lie with the motor and not the ESC. Despite the...

No, I haven't, could you advise the best way to do that please? Thanks....

The resistance feels the same as the other three motors. Thanks... John

Here you go, ignore the connectors, they're just a temporary fix until I can get to the bottom of the problem. Thanks again....

Hi, thanks for your advice. It's a new ESC fitted out of the box with a new motor, so I don't see how it can be an ESC problem? Cheers, John

Hi, thanks for getting back to me. Thanks for your advice, but the screws are not causing the problem, the failed motor has the same length screws as the other three motors, all of which work okay. I did use prop guards when I first bought the P2, but swapped back to the shorter screws when...

Hi, I'm new to this forum and would really appreciate some advice. My P2 is only a few months old and has done very little flying. After fitting an ImmersionRC transmitter one of the motors wouldn't spin, it just 'judders'. I don't think fitting the transmitter was the cause, perhaps just...

Hi, Help & advice needed please. One of the motors on my new P2 stopped working properly without any obvious cause, the motor just judders when switched on. This became evident after I had fitted a new plug & play transmitter cable & new ImmersionRC transmitter. First I was advised the motor...