Recent content by quado

this is normal all my phantom 2 visions do it the phantom 2 vision plus is slightly better the problem is as you say a grainy image on the screen, but as long as your play back images are clear and ok for video editing i would no worry my phantom 3 advanced is better because it uses light...

i know this is an old thread but i would sooner have a battery that is tight to remove rather thanks loose and fall out or loose contact during flight

the problem causing the gimbal lock error is not caused by the main gimbal pcb board. I had that problem I found that if the yaw motor on top of the gimbal (not the yaw arm) has the slightest bind on it (mine was very very slight) it causes the error to appear on the screen just thought it may...

hi all i have a phantom 2 vision with the egg shape camera when i record video or take still image pictures they are sharp and clear. but the image viewed on the screen on an ipad / android phone / android hudle is very blurry and grainy any ideas as why this is?? or is this normal on this...

Hi All Can anyone tell me if it is possible to get telemetry only without the gimbal and camera if so how please the reason i ask is the camera/gimbal do not work i use an ipad with ios operating system on it (not an android) i tried one of the following suggestions of the internet it said...

after market the reason for buying was i could not find any new genuine ones on the internet

i don't know if anyone can answer this my be solent can cast a light on it i bought 4x phantom 2 compatible batteries brand new i went out today to test them gave them all a full charge (4 leds) the outside temp was 10/11 degrees C battery 1 lasted 30 seconds of flight time then the low battery...

good point about ups

mine points down at an angle if not connected to the dji app i can control the tilt with the controller without the tilt wheel using the controller add on on the back. but once connected to the app then this cuts the manual control from the controller the app seems to take control over the...

a high pressure hose wash would be better then find the idiot using the drone and turn the hose on him/her

if it's not broken then leave it alone is my motto

have you tried an imu calibration

if you have not used the p2 vision plus for a long time and stored it away the nand chip looses script program and has to be re-flashed this applies only if you get telemetry on the screen ok but no camera picture i can re-flash them at a small cost cheaper than having to buy a video...

i use an ipad 4 with litchi but it earlier vision and dji go apps all work fine

just 4 words to say What A D**k Head this sort of person or persons need their brains examined wake up and smell the coffee look at the trouble you course for responsible drone pilots but then again if you have no brains you would not know what trouble you are causing here in the U.K we now...