Recent content by pwinters

I shoved it all the way in and still no luck. I fear I might have inadvertently bricked it by using it to do the V3.08 software "update", (I was on V3.10). Does it update the battery software automatically when you do this? If so I might have accidentally done this myself, according to some...

Wish I could tell you... can't get past the "invalid battery" screen. Wth???? :x

I agree. Thanks again for all the tips and advice. Patrick

Great idea. I'm going to do that. Thanks!

Here's another video that was really helpful. This gimbal isn't exactly the same, but the principals of the wiring are essentially the same. https://www.youtube.com/watch?v=JeE-ZOH9seg From the adapter provided, I plan to run a single pin connection from the top left pin to the bottom pin...

That's a good point. In fact, the guy in the "anonymous" video specifically mentions something about this at about 6:50. The whole thing is very strange. Why the 2 power supplies? My instinct tells me to ditch the 3 pin connectors and just solder the power wires to the incoming power on...

I think I only have one last question... there is a 6 pin connector off of the new gimbal that has two separate 3 pin cords that apparently go to the nara box for pitch and roll control. Anyone have an idea of which is which? One would supposedly go to f1 and the other to f2 but how am i...

Thx J James!

Bump..... any input guys?

Thanks for the info.. agree on the anoymous video. Haha. Where do i solder the power wires for the gimbal to the power source? At the battery connection to the board?

For any poor soul who happens to have the original problem stated at the start of this thread and happens to get to the end... I have scoured the internet for an answer to this problem and one is not obvious, so I'm going to share my experience. This problem is common for the DJI Phantom 2...