Recent content by PropDr

And there is no stress relief or cross bracing

You would have to put a screw through the circuit board

The clips transfer the load of the battery, gimbal... from the lower to the upper shell; without all the load would be on the four screws in the center of the arms.

There is this guy on youtube that took the top off a P3 It is apparent that the screw bosses on the lower shell are the problem. Material in the area are thin, have stress risers and no cross bracing. As long as the two screws inboard of the motor can transmit the torque load from the motor to...

All the pictures show the cracks in the screw pockets of the lower shell. This is a injection molded part; so, if only some units have the problem I would be looking in to the injection process, if all have the problem it is a mold design problem. I will not be able to put my hands on my P3P...

No, not that, I would have liked to have seen a shot straight down the mountain.

That looks great, actually, outstanding! Could you go back, fly further out over the edge and pint the camera straight down...