Ok here are some things I have tried.
1. Stock white dampers - horrible vibrations and jello
2. H3-2D black dampers - video no longer shakes but there are still lots of jello
3. Grey dampers - best so far, almost no jello when hovering
4. 50 degrees black dampers - worse than #3 but better...
I recently upgraded from H3-2D to H3-3D and now I am getting jellos in my videos that did not exist with H3-2D.
I had 4 flights with my H3-3D, all at the same location I had used the H3-2D before. Similar amount of sunlight and wind. ALL my H3-3D videos have varying amount of jello :evil...
Wait I'm confused. So even descending naturally, props could come off? I never really 'tightened' my propellers because I thought they self tighten during flight?
Having crashed my RC helis before twice due to VRS, I try to avoid coming straight down whenever possible. However, sometimes it just has to be done for one reason or the other.
So I was wondering, up to what kind of speed is it generally ok to descend straight down? I try to not descend any...
Hughie, you were spot on. Today I charged up the same battery and hovered around while paying close attention to the battery gauge on my iosd.
Sure enough, once past 32% or so, the battery level started dropping alarmingly quick (and I was just hovering around!!). In fact, I immediately...
Good point. It was definitely shortly before the descent started. I just checked the battery I had used for this flight (funny I never bothered to check this until now) and it's at 17%.
...which means it went from 30% to 17% in less than a minute. I think I'm going to stop relying on my 'fuel...
Earlier today I was descending straight down to land at the end of the flight (about 18 minutes in, Zenmuse H3-2D with Fatshark FPV). I usually try to avoid coming straight down to avoid VRS but today I was flying over a neighborhood (my dad had asked me if I could take a few pictures of his...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.