Recent content by PowellSkier

I wonder how fast the Phantom 4 could fly if it was able to position itself into that configuration....

I have a couple of spare controller batteries for the Phantom 4 GL300c controller. They are from a parts lot I bought. After charging them they appear to be in good condition. Voltage levels are consistent with the batteries in my other P4 controllers. Let me know if you are interested. (Located...

OK, let me get this straight, you put a Phantom 4 2312s motor on a Phantom 2?

Phantom V with DroneSense, swappable lenses, higher capacity batteries, one hour flight time, the ability to listen to Aviation frequencies around airports, parachute system, breathalyzer, IQ meter... I would also like to see relaxed restrictions from the FAA for licensed pilots without having...

I have a new P4P Y/R ESC board to sell that I guarantee is the correct part. The bottom of the board has the number P02205 stamped on it... Let me know...

Pain in the button? Stupid auto-correct...

Did you have to loosen\remove the motors at all? You could have over-tightened the screws causing it to crack... If you can, try and repair the crack, replacing the top she'll is a pain in the button since it requires desoldering and soldering the motors and removing the GPS copper shield, which...

Plugs are very different. The P4 Pro plugs are made of some cheap plastic that literally crumble when trying to unplug them. How can I tell if the GPS module is definitely bad?

Are the GPS modules the same for the P4 Standard and the P4 Pro? I have a recently purchased P4P that is not receiving any GPS signal whatsoever and I have been limited to a paltry 25 ft height when flying (in all modes).

I did not read the entire thread and he did not mention that he was on an island. He did mention an arduous hike after a 2 hour drive. Excuse me for not being more knowledgeable about mountaineering , it was only a thought...

The 300A remote should work just fine with a P4 standard. I used one for awhile until I lost my drone in a river...

If you open your RC up, first remove the USB cover and disconnect the Main Board ribbon cable. Remove the 4 screws under the rubber feet and gently pry the two halves apart. Near the bottom on the left (controller facing down) will be the connector for the battery. Disconnect this and the two...

Just took a close look at your video and it looks like the gimbal arm is bent. I would replace that as well.

Is the DJI app giving you any errors? Take the gimbal off of the drone and check all cables for tears and any damage. (Including the exposed ribbon cable on the drone) Double check the gimbal connection from the craft to the gimbal. Is there any dirt or debris that may have collected during...

DJI is no longer manufacturing drones in the Phantom 4 line (Except for the $4000 RTK mapping drone). Not entirely sure if this is true for the 2.0 version as well.