Recent content by Pleuston

  1. P

    Receiver / Controller Stuck hard to PCB

    The solder and boards are coated with some kind of clear protective coating. Remove that with a solvent and it should be easier to melt the solder
  2. P

    H3-3d gimbal issue

    An advanced IMU calibration with the gimbal attached and turned on fixed that problem for me.
  3. P

    P2 IOC Stopped Working- Help Troubleshooting Please

    Thanks again Jason. I finally got a jumper and tried the hard reset. No luck. It seemed great at first, but when I switched it to course lock the rear lights turned off completely and the P2 made crazy movements side to side. I switched to atti to get control back and the rear lights stayed off...
  4. P

    P2 IOC Stopped Working- Help Troubleshooting Please

    Thanks Jason, I did check with the RC assistant and the controller is working fine. It must be something wrong with the craft. Is there anything physical (hardware) that could cause this? If not, then it must be software. Is there any sort of hard reset for the Naza module?
  5. P

    P2 IOC Stopped Working- Help Troubleshooting Please

    IOC doesn't work on my P2 anymore, neither CL or HL work when switched on with the S2 switch. I'm hoping that there's something obvious that I'm missing or forgetting to do, and will greatly appreciate help troubleshooting this weird problem. I have all of the latest firmware and software...
  6. P

    GPS issues with Phantom

    Thanks for this info! Can you please share more details and/or pictures on how you did this? What does the battery look like, and how did you replace it with the 2032?