Hi guys,
so I recently purchased a phantom 2 with H3 3D gimbal. Had to update the firmware because the gimbal oscillating by itself. After update the gimbal was dead so I did the tweezer trick on the plate where the go pro goes and re-updated and was fine.
BUT it still moves up slightly by...
Hi Guys,
Recently acquired a Phantom 2 with the Zemuse H3-3D Gimbal.
Thought I would follow protocol and about the software after getting everything out and having a test.
I updated the Gimbal because I noticed it was moving freely and not initialising like I have seen on online tutorials...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.