Recent content by PhantomW

Thanks SkyDude! ;)

SkyDude, I did a re-flashed of camera's firmware. This is the video I took today. Seems better to my eyes. Setting is standard, 1080p 25fps, medium wide, iso 100. https://dl.dropboxusercontent.com/u/88248840/DJI00305%20-%201080p%20medium%20wide%2025%20standard.MP4 But still a bit of aliasing...

Hi SkyDude, is this StevenQX latest firmware?

Yes, cause I flash again just to make sure, and the 720p 60fps works great. I compare the bitrate for 720p 60fps is 24Mbps as compared to ard 12Mbps before. Ya, I find it very strange as why my 1080p settings are not getting the results u guys are getting. Unless the script is not activated at...

Thanks so much SkyDude. Btw I am on Phantom P2V+ v3. Only soft setting has no moire and aliasing but way too soft. Is yours v2 or v3?

Hi SkyDude, I did switched to both wide and narrow mode to ensure I am in the right mode while recording. Agreed it has nothing to do with graphics card. I tested with Gueria's latest script as there is no need to reboot when switching mode, but still getting the same moire and aliasing in both...

Hi SkyDude, Gueria, it is working now! Actually there is no problem. What I did was to view the 1080p video on my desktop and all my wire mesh effect (aliasing) is gone. My 720p video however seems to be able to play on my laptop with no problems. Does the inability of the graphics generate...

Hi SkyDude, I had tried several times but still getting not so ideal video. Seems to have a wire mesh over my video. I am still working on Gueria's first script with 1080p 25fps settings and StevenQX's 24Mbps firmware. Dropbox - DJI00236.MP4 Any advice?

SkyDude, Gueria, I am using the 24Mbps firmware. I will try one more time and attach the video here.

Ok SkyDude. I am still testing on the first script. Not the latest. When u say reboot the phantom, do u mean only the quad copter excluding transmitter and range extender?

Thanks SkyDude. However I am not getting a good video after putting in the script. After rebooting I see it changed to 1080i, exposure +2 and standard settings. Is this correct? I am experiencing a lot of noise and artifacts. Any idea what may go wrong?

Hi Gueria, I have a question on the usage of your script. For initial use, 1. Put the camera mode in 1080p30/1080p25 Narrow FOV. 2. Plug usb and unzip the "autoexec.ash" file to root of sdcard. 3. Reboot the P2V+. If I happen to change resolution while flying, how do I re-activate the script...

Follow the same procedure to flash the camera's firmware on DJI website and you will be alright.

Ok got it. Thanks so much!

Hi Nerius, the option to choose 16:9 or 4:3 screen is equivalent to wide and narrow FOV respectively?