I managed it to cut it correcty by using the old ribbon cable as a template.
Unfortunately it didn't solve my issue.
The connected smartphone gets charged, but the Controller gets not detected by my device.
Thanks for your help tho!
I just ordered a Type A 40 PIN and will try this out tomorrow!
How du you cut the cable?
Just count to 32 pins wide and use a Box cutter or a scissor and get rid of the rest of the 8 Pins?
Thanks Bpace, It would be absolutely great if this fixes the error:-)
It's a bit confusing, because the Ribbon Cable in your link has two equal ends, but the ribbon cable of the RC has one short and one longer end (like in my link below).
Therefore I rather should buy this one...
Hello everybody, I'm from Germany. I purchased my first Phantom 3 Advanced 6 years ago and I'm still into it :-)
Unfortunately my Remote is broken and that's how I ended up here. I'm excited about the community here and read a lot of interesting stuff here! Looking forward to a good time here
Hi, after some days of trying to fix the issue by myself I now want to try it here:) I am thankful for every helping hand!
Equipment:
- Phantom 3 Advanced V1.11
- GL300C Remote (should be V1.9.3 but current Version is unknown)
- Huawei P20 Pro - Android 10 / IPhone 7
- DJI Go 3.1.72
Problem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.