Re: Phantom vision RC antenna replacement - Broken coax cabl
Hi Leos ! Now I'm back home.
I wrote to my dealer, they answered they will provide another one instead of a new antenna. My problem is I live in Brasil and I will have to send the TX and wait a lot of weeks to have it back here. I...
Re: Phantom vision RC antenna replacement - Broken coax cabl
You´re absolutely right. But my RC was not running the latest software, and this was the reason I had to open it.
Although being an experienced in electronics, I realized how fragile is the conection between the coax and the IPX...
Re: Phantom vision RC antenna replacement - Broken coax cabl
Leos - I'm leaving for a trip today. This is a IPX 1.3 coax connector cable. I sent a message to DJI and my dealer too. I hope these guys answer soon. Let me know if you have any news. Tks
During opening the my Phantom Remote Control for the last software upgrade, and even with all appropriate care, the antenna wire broke from the mini conector . Where I can find the replacement antenna (with cable) to my RC ?
This cable is really fragile, and as the USB port is not outside of RC...
Hi folks
Some information about general compass calibration and how electronic compass works :
Very interesting text about electronic compass and I think DJI guys should know about this. :idea:
It would be a good solution for this irritating problem on Phantom copters
(Source...
I´m experiencing the same problem with my Phantom Vision 2. Several attempts to calibrate the compass. I achieved "MOD " around 1700/1800's, it was around 6500 !!! . Sometimes the compass fails and I get the flashing yellow. I think the problem is the area around. Try another site, clear of any...
Very weird at all ! Anyway worth a try, since you have nothing to lose because as you said, they will replace it for a new one.
I wanted to open my camera, but I didnt have enough time to do it. :idea: Never give it up ! Keep walking, I mean trying :lol:
Although I'm a pilot, I'm an expert in electronics too. Most electronic devices such as computers, routers and etc., have a reset button that brings the device into the startup state and is active for a short time after powering on. As the camera does not present this apparent button (it may be...
I've been reading your post and all the suggestions on how to solve it. Try this:
Unplug the white cable from camera and move the switch to the on position . Turn the Phantom on and check if the camera stabilization works, tilts it up and down. Now, while pressing the white button underneath the...
Hi Micucci.
I'm trying to understand the problem too. I suppose you have charged both batteries properly and anyway it happens with any of them. If you want to explain your problem writting in portuguese may be I could help you better. If batteries are OK, it could be a bad contact or loose...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.