Recent content by omaha330

Hi, I have a few questions/issues I hope someone can help me with. The first question: After adding a CAN-BUS and an iOSD module I went for a test flight and when I turned on everything I noticed that the fpv display screen now had "Landing Assistance Enabled" , which looked very similar to...

You should plug it into a PC, it gives you many options for programming also you can upgrade the firmware (the software that runs on the hardware) If its a used drone, you should load all the default settings. If your really new, stay in Phantom-Mode until your a comfortable, then switch to...

Re: P2 very unstable after crash + video well I would rotate the blades and see if it effects the direction any. Is there power lines above? Try a different location, part of the sky is blocked where the video shows, you may have 6+ sats but none in the direction of the building. Check the...

MOD can you push this to the right forum plz

I did try both ports...F1 & F2

hello, thank you, the camera & gimbal are DIY kits off ebay, http://www.ebay.com/itm/181377401469 The carbon-fiber gimbal is an after-market kit for Go-Pro but modified for centre mount camera , it was around $60 http://www.ebay.com/itm/151193203839 Teeeesha <3

I did a quick fix (see pic above ) to keep it straight until i can figure it out how to pan pan

wow , that was friendy :(( I guess I posted here because it went out from the factory is a "Phantom II Vision +" but in this case it is carrying a diferent gimbal and camera I want to use. ~Tasha~

I recently built a custom gimbal but im having a little issue getting it workingh properly and I’m not sure on the optimal way to control it. If I plug the Gimbal (brushless motor) into the F1 port on the Naza-M-V2, all it does is lock its position, but it doesn’t move or respond to any...