Recent content by Ohary

Tried a few other cables, no lag. Went back to initial cable, no lag either. Go figure...

On last 2 flights I've noticed quite a video lag (about 7 seconds). Tried it on both Samsung Galaxy 4 and 5 same result. Any help reducing the lag appreciated.

Good b/c the one I just ordered shipped from Harrisburg, PA. :D

Thanks, I figure it is, but DJI support says no, lol. I will post here when I test it out to confirm.

I had a similar issue. I had to open the controller (somewhat difficult as the screws are hidden behind the bottom rubber pads, and you also have to remove the USB ribbon cable on the rear of the controller). When you access the lipo battery, make sure the connection is secure. That was my...

Technically 15+ hours to go before it's the 15th in China! ;)

Well, you can add me to the list just picked one up on the Massdrop for $910 shipped. I expect it is going to take a little longer. Probably end November.

If you can get out to Heli Direct in Malden, they may have some by then. Of course I'd call first.

I'm not sure it does. If the sensor is higher resolution, a higher flight will offset the wider angle. The upside being an increase in accuracy. Again, this all depends if the CCD/CMOS? sensor is more tightly packed.

P3 Advanced here as well for photogrammetry.

I think Pete ought to revise this post as his testing is simulated and not actual. I also tend to agree with the others that have stated a narrower angle lens should result in less distortion effects. The Mavic should in theory produce better results (supposed softer images, not considered). I...

A lot of us use the P3/4 for aerial mapping which uses stills. Can anyone please post a comparison between the two?

I took and passed the test as well. I'd recommend knowing cold all the drone regulations, that covers about 1/2 the test, but you should also know how to read the Airmans Knowledge test manual, and as Rj says, the frequency/communication and definitely know how to read the legend in the...

I'm having same problem since updating. Does anyone have a link to the software upgrade?

I'm getting similar issue with my P3A. This all seemed to happen immediately after I applied the latest update. Now it will not bind with the controller. I do get video transmission, but nothing when it comes to controller. I wish there was a way I could go back to an earlier update.